1. Slider and nut oiling maintenance (Nut maintenance mainly involves the SDM/MSDM series of lead screw slides) Oiling process:

Stop the machine → Open the end cover of the slide → Fill the grease of the slider → Confirm that the old oil has been used up → Remove the excess grease → Run the machine for ten minutes to balance the grease pressure inside the slider → Remove the residual oil on both sides of the slider and at both ends of the slide rail → Normal operation maintenance time of the machine: If the slide runs continuously for 8 hours a day, it can be inspected and maintained once a month. The frequency can be as low as once every six months.

2. Specifications of lubricating oil used for the slide table

It features excellent low dust emission and is suitable for cleanroom environments. It has outstanding wear resistance and provides good protection for components. Available in beige and white, it is applicable at temperatures ranging from -45 to 125 degrees. Special guide rail lubricating oil will do.

3. Precautions for using oil injection products

Inject the new oil product into the screw oil injector and the slider oil injector using an oil gun. The oil gun is fired until the old oil overflows on the outside of the nut and the slider (the old grease accumulates on both sides of the slider and the nut). Wipe the old oil products clean with a cloth that cannot be used. Repeat the first three steps until the newly injected oil overflows on both sides of the slider and the nut, and there is no residual old oil. The color of new oil products is milky white or beige, while that of old oil products is black or dark yellow. Test run the machine for ten minutes. After the oiling is completed, each shaft should be operated continuously for more than ten minutes to ensure that the lubricating grease inside the slider can be evenly combined with the balls in the slider.

4. Maintenance of the rack in the ZDM series of rack slides

Lubricate with grease, apply oil regularly and clean regularly. Ensure a good lubrication environment for the gears and racks. Select anti-corrosion and anti-rust lubricating oil of suitable viscosity and apply it directly.

5. Precautions for regular cleaning of the slide table

Please use a soft cloth to wipe off the dust. Never use high-pressure air to remove surface dust. Do not wipe with organic solvents. You can use a soft cloth dipped in alcohol to wipe.

6. External inspection of the slide table

Is there any abnormal noise or resonance phenomenon when the industrial gsh17s long stroke actuator is in operation?

7. Internal inspection of the slide table: Check whether there are any foreign objects inside the slide table.

Check if the lubricating oil between the slider rail and the screw has deteriorated. If it has, please clean it immediately and replace the lubricating oil. Be careful not to let sharp objects or tools strike the surface of the tooth profile. Do not allow iron cutting to enter the interior of the screw. The assembly shaft end must not be bumped or scratched. There are loose screws in the slide table and they need to be retightened.

8. Maintenance operations can only be carried out when the slide table (machine, machinery) has stopped running and the power is cut off.

industrial gsh17s long stroke actuator https://www.pi-robot.com/GSH17S/